News
Where manufacturing begins
 
July 20 2017

AMEC takeaways

The third edition of the Additive Manufacturing European Conference (AMEC) took place in the European Parliament on 7 June 2017, bringing together 100 participants from the AM industry, authorities and academia. This document aggregates the main TAKEAWAYS discussed during this event. Europe has a...[more]

Category: Additive Manufacturing, Publications, News, Cecimo

July 13 2017

International Conference on Additive Manufacturing at EMO Hannover 2017

Organized on 21 September 2017 during EMO Hannover 2017, CECIMO’s “International Conference on Additive Manufacturing” aims to capture some of the most interesting advancements in this fast-evolving landscape. Industry leaders, high-level researchers and policy-makers will illustrate and discuss...[more]

Category: News, Cecimo, Additive Manufacturing

June 16 2017

Additive manufacturing industry asks the EU to support research and education

Brussels, 8 June 2017 - For the third consecutive year, CECIMO organized the “Additive Manufacturing European Conference” (AMEC) on 7 June 2017 in the European Parliament in Brussels (Belgium). The event was a great success, gathering more than a hundred participants among industry leaders and...[more]

Category: Press releases, Cecimo Press releases, News, Additive Manufacturing Press releasesCecimo Press releases

June 16 2017

European Additive Manufacturing Strategy

Category: Publications, News, Additive Manufacturing

March 27 2017

Registrations to AMEC III are open!

Following the success of the previous editions, CECIMO is organising the 3rd edition of “Additive Manufacturing European Conference” on the theme:“Boosting the competitiveness of the European industry by supporting the adoption of additive manufacturing”7 June 2017, from 14.00 to 18.00European...[more]

Category: News, Additive Manufacturing

March 16 2017

CECIMO to set up an expert group on AM

CECIMO is conducting an EU project on additive manufacturing with the following goals: map out current and potential application areas for additive manufacturing in Europeidentify relevant non-technological barrierspropose collaborative business models and lay out a roadmap to industrialize this...[more]

Category: Additive Manufacturing, News

March 13 2017

CECIMO presents the first results of additive manufacturing skills projects

CECIMO has two projects on skills needs for additive systems: METALS – Machine Tool Skills for Alliance (CECIMO is coordinator) - and 3D PRISM – 3D Printing Skills for Manufacturing. On 13 March 2017 Filip Geerts, CECIMO Director General, will present the current findings of both projects at a...[more]

Category: News, Additive Manufacturing

Displaying results ###SPAN_BEGIN###%s to %s out of ###SPAN_BEGIN###%s
<< First < Previous 1-7 8-14 15-21 22-28 29-35 36-40 Next > Last >>